Implosion proof PP/PC desiccators with a volume of 9.2 l. Will take vacuum of -986.7 mbar with loss (absolut zero: -1013 mbar) not exceeding 26.7 mbar in 24 hours.
Volume: 9.2 l
Diameter: approx. 250 mm
Outer hight: approx. 300 mm
Inner hight: approx. 225 mm
General dimensional tolerance: ±0.2 mm
Max. temperature range in normal use: 30-35 °C
The transparent polycarbonate cover seals onto a neoprene ‘0’ ring set into the flange of the PP base. A little grease spread on the ‘0’ ring will assist in establishing initial vacuum. Within the desiccator is a removable pan for holding a drying agent.
Vacuum release tap/non return valve assembly is included; specially grooved stopper in this assembly allows air, when required, to be re-admitted very slowly to avoid disturbing the contents.
- Remove the cover in PC - insert the samples in the pan.
- Open the vacuum retention valve (PE needle) connect the tube of the pump to the dessiccator spigot in order to create vacuum.
- Close the vacuum retention valve.
Valve for hose with inner-Ø 10 mm, for the connection of a tube with inner-Ø 6 mm please order the adapter set (item no. 390 104-RS) separately.
The desiccator PP / PC is supplied without a perforated plate, which is not required if the desiccator is only used for the venting of resins or silicones. On the one hand, perforated plates serve to enlarge the supporting surface; on the other hand, they are required if substances are to be dried in the desiccator.
all Prices price incl. VAT, possibly plus shipping
Ratings for Desiccator (PP/PC / 9.2 liter / Ø 250 mm)