Processing time
Heat resistance
Certificates etc.
Color
 
 
 
 
 
 

More Information: Glues can be found here

Epoxy Casting Resins

Casting resin type Description Casting thickness Processing time Curing Mixing ratio
Resin : Hardener
Price
Epoxy Casting Resin
+ Hardener CRYSTAL-CLEAR
For high casting thicknesses in one step 7 - 10 cm 600 minutes 48 - 62 hours 100 : 45
parts by weight
€€€
Epoxy Casting Resin EXTRA 600
+ Hardener EXTRA 600
For medium and higher casting thicknesses in one step 5 cm 600 minutes 24 - 72 hours 100 : 42
parts by weight
€€
Epoxy Casting Resin
WATER-CLEAR
+ Hardener W 300
For lower casting thicknesses in one step,
multilayer potting is possible.
2 cm 300 minutes 24 - 72 hours 100 : 35
parts by weight
Epoxy Casting Resin
OCEAN BLUE
+ Hardener W 300
Transparent blue colored. For smaller
thicknesses in on step, multi-layer potting
potting is possible.
2 cm 300 minutes

24 - 72
hours

100 : 35
parts by weight
Epoxy Resin HT 2
+ Hardener HT 2
For low casting thicknesses and coatings 0.5 cm 45 minutes 12 - 24 hours 100 : 48
party by weight
€€€

€ = low price, €€ = medium price, €€€ = higher price

All data on thicknesses, processing time and curing time are only approximate values. A large number of parameters such as temperature, casting volume, substrates have a decisive influence. The values may therefore deviate considerably in practice.

What is important in processing?

  1. Determine the required resin/hardener quantity. The R&G resin calculator helps you to do this.
  2. Weigh components accurately and mix resin and hardener thoroughly (drill +mixing propeller); then repot into a clean container and mix again.
  3. Allow the batch to stand for 15 - 30 minutes to deaerate. Remove rising air bubbles, which lie as foam on the surface after casting, with a hot air gun or gas flame (fire hazard).
  4. Set up fans (cold air) above the casting (e.g. Rivertable); this has proven effective in preventing overheating.