Epoxy Casting Resin EXTRA 600 + Hardener

Epoxy Casting Resin EXTRA 600 + Hardener EXTRA 600, set of two components

The Epoxy Casting Resin EXTRA 600 is a special system with long pot life and low exothermicity.

• Free from phenol, alkylphenol and benzyl alcohol
• Highly transparent components
• Good UV resistance
• Largely free of air bubbles
• Polishable, hard surface
• Very good impact strength
• Low shrinkage
• Can be modified with all kinds of fillers (metal powder, effect pigments, dry sand, etc.)
• Can be coloured with transparent colours

Mixing ratio:
100 : 42 parts by weight of resin to hardener

Processing time*: approx. 600 minutes (up to gelling)
Mixing viscosity (at 25 °C): 350 mPas
Curing time: approx. 24 hours up to several days (depending on volume, layer thickness and temperature)
Processing/curing temperature: 15 up to 20 °C (depending on volume and layer thickness)

Technical data Resin:
Viscosity(at 25 °C, DIN 530315): 2.200 ± 300 mPas
Epoxy value, DIN 536188: 0.48 ± 0.02
Epoxy equivalent weight: 210 ± 8
Colour code (Gardener): ≤ 2
Density (at 20 °C): 1.10 ± 0.02 g/cm³
Shelf life (at 23 °C in original container): min. 12 months

*) determined arithmetically

Technical data Hardener:
Viscosity at 25 °C, DIN 530315): 20 ± 15 mPas
Amine value (mg KOH/g) according to DIN 16945: 310 ± 20
H-Equivalent (g/Val.): 88.5
Colour code (Gardener): ≤ 1
Density (at 20 °C): 0.96 ± 0.02 g/cm³
Shelf life (at 23 °C in original container): min. 12 months

Application:
Aquaristics, terraristics, arts and crafts, wood finishing, furniture construction (Rivertable), slides, aircraft, ship, car and railway model construction.

Processing:
The processing and curing time depends strongly on the volume applied and the ambient conditions. Therefore we cannot give any values because of the large number of variables (e.g. volumes, geometries, etc.). In our opinion, however, the processing time is sufficiently long to allow even larger grouting. Due to the reduced reactivity, the curing time is longer and is certainly several days.

The tool with which the components are stirred plays an important role in mixing the components; it should generate as little air entrainment as possible. When mixing, care must be taken to ensure that as little air as possible enters the mixture. Note: the resin component already contains an additive that promotes venting.

We recommend covering the casting to prevent dust from entering (the surface of the casting must not be touched). If necessary, the curing process can be accelerated by a slight application of heat after allowing the casting to rest overnight.

Resin Calculator

Calculate resins
online for free!
 
 
 
 

 

R&G laminate calculator

Calculate laminates
online for free!
 
 
View Video
 

More Information about packaging kinds of fabric in the R&G Wiki