Silicone rubber KDSV-10 WHITE (set of two components)

KDSV-10 is a pourable, condensation-curing 2-component silicone rubber with low viscosity.

Very soft, for models with strong undercuts.

• Excellent flowability
• Easy processing
• Very good tear resistance

Processing:

Standard:

Mixing ratio: 100 : 2 parts by weight component A : component B
Processing time: 50 minutes
Curing time (HR 25 °C): 4-5 h

Alternatives:

Mixing ratios from 100 : 2 up to 100 : 3

Processing time (100 g in a cup at 25 °C):
100 : 2 = approx. 50 minutes
100 : 3 = approx. 30 minutes

No heat of reaction occurs during vulcanisation, so that even larger quantities (e.g. 10 kg) can be poured without the risk of overheating.

Technical data:

Colour: White
Mixing viscosity: 13.000 ± 2.000 mPa·s
Shore A hardness: 10 ± 2
Tensile strength: > 2.4 N/mm²
Elongation at break: > 640 %
Tear resistance strength: > 13 N/mm
Linear shrinkage (after 7 days): ≤ 0.3 %

Additional information:

Customer information:
The release agent Semiperm™ Monofilm in combination with PARTALL® Coverall Film PVA is suitable as a safe release agent for silicone moulds. This combination of release agents provides a barrier layer so that casting with epoxy resins is also possible without any problems. The service life (durability) of the moulds is significantly extended.
The release agent Semiperm™ Monofilm is applied with a brush. After flash-off, PARTALL® Coverall Film PVA is applied, also with a brush or sponge. For more information on processing, see the release agents.
PARTALL® Coverall Film PVA is transferred to the casting, washed off with water after demolding and reapplied before each impression.

New: We now supply our packages (up to 5.2 kg) with a dispensing pipette.*

* In general, we recommend a dispensing pipette for exact dosing of smaller quantities, and a dosing syringe for a little larger quantities. Mixing vessels with smooth walls and smooth bottoms are particularly suitable for mixing.